Section 9: Installing The Performance Crossover Forward-Facing - RECARO Performance Crossover User Manual

Removing the Seat from the Base
1. With one hand pull up on the
1
2. Lift the seat up and out of the
QuickRelease strap behind the
headrest and with the other hand
pull up on the seat frame near
the front of the seat.
base.
30
Section 9: Installing the Performance
Crossover Forward-Facing
WARNING!
1. Ensure the base is properly
2a
2. Face the seat toward the front
2b
3. Adjust the recline of the seat
3
4. Connect the top tether hook to
DEATH or SERIOUS INJURY
can occur
installed and there are no
objects on top of the base.
of the vehicle and place the
seat into the base. Pull up on
the seat to verify that all four
attachment rods are secured to
the seat.
to the first two positions by
pulling the lever on the front of
the base. The seat back should
match up with the vehicle seat
back.
the anchor.
NOTE: Do NOT use a cargo tie
down for the tether attachment.
Check your vehicle owner's
manual if you are not sure
where the tether attachment is.
31