Table of Contents
Advertisement
3. While pressing the base firmly
3
4. Slide the shoulder belt into
4
28
into the vehicle seat near the
belt path, pull the vehicle seat
belt to remove any slack.
The base is secure when it
cannot be moved more than 1
inch (2.5 cm) in any direction at
the belt path.
the lock off after the slack is
eliminated.
Section 8: Installing the Performance
Crossover Rear-Facing
WARNING!
1. Ensure the base is properly
2a
2. Face the seat toward the rear of
2b
3. After initial connection to the
3
DEATH or SERIOUS INJURY
can occur
installed and there are no
objects on top of the base.
the vehicle and place the seat
into the base. Pull up on the seat
to verify that all four attachment
rods are secured to the seat.
base, the seat will be at its
upmost position. Recline the
seat by pulling on the recline
lever so that the level to ground
line on the side of the seat is
parallel with the ground.
29
Advertisement
Table of Contents
Need help?
Do you have a question about the Performance Crossover and is the answer not in the manual?
Questions and answers