Table of Contents
Advertisement
4. If further cleaning is
4
5. After removing from the
5
6
6. Slide the harness out of the
7. Remove the headrest cover
7
36
necessary, the harness
straps will need to be
removed through the bottom
of the seat.
base, turn the seat over and
locate the metal harness
brackets. Unclip the metal
brackets from the seat
frame and slide them up
thorough the slots in the
plastic. Remove the bracket
by sliding each one through
the slots in the plastic.
AutoOpen harness pad.
by unfastening the Velcro ®
on the back of the headrest
and pulling forward. Slide
the HERO insert off of the
harness.
Trim Cover Installation
If the headrest cover was removed:
1
4
1. Slide the HERO insert pads
through the two slots on the
headrest cover so that all
(3) RECARO logos are on
the same side. Thread the
harness straps through the
back of the headrest cover
and then the HERO insert
pads.
2. Slide the plastic backrest
piece on the seat into the
backrest pocket on the
cover.
3. Slide the headrest cover
onto the headrest plastic
in the seat and fasten the
velcro on the back of the
headrest cover.
4. Replace the AutoOpen
Harness pad by sliding
the harness straps down
through then out toward the
middle of the pad.
37
Advertisement
Table of Contents
Need help?
Do you have a question about the Performance Crossover and is the answer not in the manual?
Questions and answers