Panasonic CQ-VD7001U Operating Instructions Manual page 44

Settings
(AUDIO continued)
SP SETUP
(Speaker set up)
43
Setting the absence/presence and size of each speaker
FRONT
: for large speakers, when bass playback is
LARGE
possible (at least 100 Hz or lower)
SMALL : for small speakers, or when bass playback is
not possible
CENTER
: for large speakers, when bass playback is
LARGE
possible (at least 100 Hz or lower)
SMALL : for small speakers, or when bass playback is
not possible
NONE : when not using a center speaker
* A center speaker (option, EAB-CF2 recommended) is
required.
SURROUND
LARGE : for large speakers, when bass playback is
possible (at least 100 Hz or lower)
SMALL : for small speakers, or when bass playback is
not possible
NONE : when not using a surround speaker
SUB - W
YES : when using a subwoofer
NO : when not using a subwoofer
* A subwoofer (option, CJ-HD302 recommended) is
required. A power amplifier (option) is also required for
connecting a subwoofer.
Note:
¡While the private mode is active, only
adjusted.
[MENU]
44
CQ-VD7001U
(continued)
(Front speaker setting)
default:
LARGE
(Center speaker setting)
default:
NONE
(Surround speaker setting)
default:
LARGE
(Subwoofer speaker setting)
default:
can be
FRONT
: Previous menu
[MODE]
: Previous menu
SP LEVEL
(Speaker level)
Adjusting the output balance of each speaker
FRONT L
] [
: down, : up
CENTER
] [
: down, : up
FRONT R
] [
: down, : up
R SURROUND
¡
] [
: down, : up
L SURROUND
¡
] [
: down, : up
SUB - W
] [
: down, : up
Setting range: –10 dB to +10 dB (1 dB steps)
A test signal (a continuous tone) is output from each
speaker for approximately 2 seconds.
Adjust the output balance so that the tone appears to have
the same volume from each speaker.
Adjusting the output balance:
Adjust the volume of all of the other speakers to the volume
level of the speaker from which the test signal appears to be
the quietest.
¡If the speaker setting is
speaker, the test signal is not output and that speaker
cannot be selected.
¡ Turn rotary volume controller or press [ } ] or [ { ]
NO
(VOL) to adjust the volume of the test signal.
: Select/adjust
: Quit
: Quit
[]] [[] [}] [{] : Select/adjust
(Left front speaker output bal-
ance)
(Center speaker output balance)
(Right front speaker output bal-
ance)
(Right surround speaker output
balance)
(Left surround speaker output
balance)
(Subwoofer speaker output bal-
ance)
Default: ± 0 dB for all speakers
(none) or (no) for a
NONE NO
Note:
¡While the private
mode is active, only
and
FRONT L
can be
FRONT R
adjusted.
[ENTER]
: Determine