Heatilator CD4236-MOD Installation Manual page 47

A. Vent Components Diagrams (continued)
8-1/8 in.
(206 mm)
15 in.
(381 mm)
Power Vent Inline
12-1/2 IN.
(318 mm)
Figure 12.5 Vent Components
Heatilator • CD4236-MOD, CD4842-MOD Installation Manual • 2241-901 Rev. C • 6/15
13 in.
(330 mm)
Fire Risk.
• When using DVP-HRC-SS and DVP-HRC-ZC-
SS termination caps on top vented fi replaces, a
6 inch minimum vertical vent section is required
before installing fi rst elbow.
HORIZONTAL TERMINATION CAP
13-5/8 IN.
346 mm
12-1/2 IN.
318 mm
20-3/4 IN.
527 mm
PVI-SLP
9-3/16 IN.
(233 mm)
13-5/8 IN.
(346 mm)
SLP-LPC
SLP Low Profi le Cap
Effective Length
5-3/4 to 8-3/8 in. 5-1/2 in.
146 to 213 mm 140 mm
87°
WARNING
DVP-HRC-SS
DVP-HRC-ZC-SS
Optional Wire Harness
DESCRIPTION
10 ft. PV Wire Harness
20 ft. PV Wire Harness
40 ft. PV Wire Harness
60 ft. PV Wire Harness
80 ft. PV Wire Harness
100 ft. PV Wire Harness
Note: Wire harnesses required to power the PVI-SLP
connect to the appliance and are ordered separately from
PVI-SLP. Contact your dealer to order.
Note: Use only approved termination caps with the PVI-
SLP. See instructions included with PVI-SLP kit.
16 IN.
406 mm
4-1/2 IN.
114 mm
16-11/16 IN.
424 mm
8-3/8 in.
213 mm
3°
10-1/2 in.
267 mm
10-7/8 in.
276 mm
PART NUMBER
PVI-WH10
PVI-WH20
PVI-WH40
PVI-WH60
PVI-WH80
PVI-WH100
15 IN.
(381 mm)
16-11/16 IN.
(424 mm)
47