Table of Contents
Advertisement
ASSEMBLY
Attaching Tool ( Figs. 13-14 )
• Adjust length of shoulder harness (9) straps so that the metal tool support clasp (9b) is approximately
15cm below your waist; secure the product to the harness by using the snap clip (9a).
• Place snap clip (9a) over the flange on the metal tool support clasp (9b)
• Insert the clasp release bar (9c) into the slot opening on the base of the metal tool support clasp (9b).
• Attach the snap clip (9a) to one of the three height adjustment positions (B) to make most comfortable
for your height and securing tool.
• In case of emergency hold the upper shaft with the left hand, and use the right hand to pull the
red nylon ribbon that is attached to the clasp release bar (9c) upward which will release the clasp
release bar (9c) from the tool.
• The clasp release bar (9c) will release the product from the snap clip (9a) automatically once red
nylon ribbon has been pulled upward.
To remove the shoulder harness (9) from one of the three height connection positions (B), press
open the snap clip (9a).
• Before performing any work, ensure that the angle of the cutting head is parallel to the surface
being cut (Fig. 19).
Metal Tool
Support
Clasp (9b)
Snap Clip
(9a)
Clasp Release
Clasp Release
Bar (9c)
Bar (9c)
Snap Clip (9a)
Height Adjustment
Positions (B)
Fig. 13
15
Metal Tool
Support
Clasp (9b)
Hip
Protection
Pad (9d)
Fig. 14
Advertisement
Table of Contents
