Operating Functions - Prolight CYBER4 User Manual

CYBER 4
10
RGB Offset Operation
This controller has a built-in color fade program that will chase between fictures sequentially 1-4 con-
tinuously. Please see the instructions below for this operation.
• Press [RGB FADE] and [AUTO] simultaneously; the LED indicator positioned above [FIXTURES] will light
sequentially activating the devices connected to each other.
• Adjust the [SPEED TIME] Fader to the desired level to set the speed execution.
• Adjust the [FADE TIME] Fader to the desired level to set the Fade Time.
• Adjust the [MASTER DIMMER] Fader to the desired level.
• [WHITE DIMMER] may be adjusted; however, it will not be effected by this mode.
NOTE - Please be sure that the Strobe and Blackout, functions are not overriding the controls.
Sound will function in RGB OFFSET Mode.
Color Macro Operation
The CYBER4 has preset color macros, some with different intensities. Please see the instructions below
for this operation.
• Press [COLOR MACRO] until the appropriate LED indicator lights.
• Using the [SPEED TIME] Fader to select the color.
• Adjust the [FADE TIME] Fader to the desired level to set the Fade Time.
• Adjust the [MASTER DIMMER] Fader to the desired level.
• [WHITE DIMMER] may be adjusted; however, it will not be effected by this mode.
NOTE - Please be sure that the Strobe and Blackout, functions are not overriding the controls.
This mode applies the same color to all fixtures
Sound will not function in COLOR MACRO Mode.
Sound Operation
This controller has preset chases. These chases are normally triggered using the Speed Time. However,
they can be triggered using the built-in microphone, as well. Please see the instructions below for this
operation.
• Press [SOUND] until the appropriate LED indicator lights.
• Adjust the SENSITIVITY Fader to the desired level (turn clockwise to increase sensitivity).
NOTE - Please be sure that the Strobe and Blackout functions are not overriding the controls.
Sound will function in CHASES Mode.
Sound mode will only work in one of the following modes: RGB FADE, AUTO and CHASES.

4.3 OPERATING FUNCTIONS

Strobe
• Press [STROBE] until the appropriate LED indicator lights.
• Adjust the [SPEED TIME] fader to the desired level .
• In order to return to the desired mode, press [STROBE] until the appropriate LED indicator is off.
NOTE - This function may be activated while operating in any other mode (PRESET, RGB FADE, AUTO,
CHASES and COLOR MACRO).
In order to deactivate this function, the mode must be entered, and the fader must be set to 0.1M (fully
down). Then, deactivate [STROBE].
Blackout
• Press [BLACKOUT] until the appropriate LED indicator lights.
• Adjust the [FADE TIME] fader to the desired value to determine how quickly the lights will fade out.