6
- 2 - INSTALLATION / CONNECTIONS
2.1 INSTALLATION
Install the CYBER4 on a plane surface. Please see the drawing below (fig.2), which shows the back of the
controller. It details the dimensions for mounting. This will aid in placing the holes for installation.
2.2 CONNECTION OF THE DMX LINE
DMX connection employs standard XLR connectors. Use shielded pair-twisted cables with 120Ω imped-
ance and low capacity.
The following diagram shows the connection mode:
DMX - INPUT
XLR plug
Pin1 : GND - Shield
Pin2 : - Negative
Pin3 : + Positive
CYBER 4
312 mm
270 mm
Fig.2
Fig.3
DMX - OUTPUT
XLR socket