Addressing; Projector Addressing; Functions And Settings; Basic - Prolight CYBER4 User Manual

8

- 3 - ADDRESSING

3.1 PROJECTOR ADDRESSING

The CYBER4 allows you to program 4 scanners. You have to address every projector to the respective starting
address. Please note that the DMX operator assigns the DMX starting addressed every 16 steps. (see chart).
NOTE - All projectors with the same starting address work synchronically.
CHART FOR DMX ADDRESSING

- 4 - FUNCTIONS AND SETTINGS

4.1 BASIC

This fixture runs on 12 VDC, 500 mA. Before powering on the unit, make sure the power supply voltage
to which you are connecting it is correct. Connect the connection cable of the power unit with the DC in
socket. Plug the power unit into your outlet. Switch on the unit with the power switch (1). The CYBER4 is
ready for operation. After operation, switch off the unit with the power switch.
ATTENTION - To determine the power requirements for a particular unit, see the label affixed to the back
plate of the unit or refer to the unit's specifications sheet.
• All devices must be powered directly off a switched circuit and cannot be run off a rheostat (variable re-
sistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
• Before applying power to a fixture, check that the source voltage matches the fixture's requirement.
This information is located on the power adaptor that is included with your unit.

4.2 OPERATING MODES

The CYBER4 has different operating modes. Select one or more [FIXTURES]
Preset Operation
This controller has preset color macros. There are nine color macros to choose from, which may be ac-
cessed using the nine preset buttons. Please see the instructions below for this operation.
• Press [PRESET] until the appropriate LED indicator lights.
• Adjust the [SPEED TIME] Fader to the desired level to set the Fade Time.
• Adjust the [MASTER DIMMER] Fader to the desired level.
• [WHITE DIMMER] may be adjusted; however, it will not be effected by this mode.
• Select one of the nine preset color macros: [RED - ORANGE - YELLOW - GREEN - CYAN - BLUE - PURPLE - MAGENTA - WHITE].
• The Fade time and dimming may now be readjusted.
NOTE - Please be sure that the Strobe and Blackout, functions are not overriding the controls.
Sound will not function in Preset Mode.
Fixture or Default DMX
scanner # starting address
1 1
2 5
3 9
4 13
CYBER 4
Binary Dipswitch
setting
1 ("On" position)
1, 3 ("On" position)
1, 4 ("On" position)
1, 3, 4 ("On" position)