D-4
WARNING
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes away from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY - disconnect negative
cable from old battery first and connect to new battery
last.
• CONNECTING A BATTERY CHARGER - Remove bat-
tery from welder by disconnecting negative cable first,
then positive cable and battery clamp. When rein-
stalling, connect negative cable last. Keep well venti-
lated.
• USING A BOOSTER - connect positive lead to battery
first then connect negative lead to engine foot.
BATTERY ACID CAN BURN EYES AND SKIN.
• Wear gloves and eye protection and be careful when
working near battery. Follow instructions printed on
battery.
BATTERY
1.
When replacing, jumping, or otherwise connecting
the battery to the battery cables, the proper
polarity must be observed. Failure to observe
the proper polarity could result in damage to the
charging circuit. The positive (+) battery cable
has a red terminal cover.
2.
If the battery requires charging from an external
charger, disconnect the negative battery cable
first and then the positive battery cable before
attaching the charger leads. Failure to do so
can result in damage to the internal charger
components. When reconnecting the cables,
connect the positive cable first and the negative
cable last.
HARDWARE
Both English and Metric fasteners are used in this
welder.
MAINTENANCE
Oil Filter
Air Filter
Element
Air Filter
Pre-Cleaner
Fuel Filter
Spark Plugs
(Resistor
Type)
* Oil capacity increases from 2.0 Qts. to 2.1
Qts. when using this filter.
RANGER® 3 PHASE
ENGINE MAINTENANCE PARTS
KOHLER C23S
KOHLER 12 050 01
FRAM PH8172*
KOHLER 47 083 03
FRAM CA79
KOHLER 24 083 02
KOHLER 24 050 10
CHAMPION RC12YC
(.030" GAP)
D-4