Maintenance; Engine Adjustments; Slip Rings; Engine Maintenance Parts - Lincoln Electric RANGER 225 Operator's Manual

D-3

ENGINE ADJUSTMENTS

OVERSPEED IS HAzARDOUS
WARNING
The maximum allowable high idle speed for this
machine is 3750 RPM, no load. Do NOT tamper
with governor components or setting or make any
other adjustments to increase the maximum
speed. Severe personal injury and damage to the
machine can result if operated at speeds above
maximum.
------------------------------------------------------------------------
Adjustments to the engine are to be made only by a
Lincoln Service Center or an authorized Field Service
Shop.

SLIP RINGS

A slight amount of darkening and wear of the slip rings
and brushes is normal. Brushes should be inspected
when a general overhaul is necessary.If brushes are
to be replaced, clean slip rings with a fine emery
paper.
CAUTION
Do not attempt to polish slip rings while engine is
running.
------------------------------------------------------------------------
* Oil capacity increases from 2.0 Qts. to 2.1 Qts. when using this filter.

MAINTENANCE

bATTERY
1. When replacing, jumping, or otherwise connecting
2. If the battery requires charging from an external
HARDWARE
Both English and Metric fasteners are used in this
welder.

ENGINE MAINTENANCE PARTS

KOHLER C23S
KOHLER 12 050 01
Oil Filter FRAM PH8172*
Air Filter KOHLER 47 083 03
Element FRAM CA79
Air Filter KOHLER 24 083 02
Pre-Cleaner
Fuel Filter KOHLER 24 050 10
Spark Plugs CHAMPION RC12YC
(Resistor (.030" GAP)
Type)
RANGER® 225
WARNING
GASES FROM bATTERY can explode.
• Keep sparks, flame and cigarettes away from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW bATTERY - disconnect negative
cable from old battery first and connect to new bat-
tery last.
• CONNECTING A bATTERY CHARGER - Remove bat-
tery from welder by disconnecting negative cable
first, then positive cable and battery clamp. When
reinstalling, connect negative cable last. Keep well
ventilated.
• USING A bOOSTER - connect positive lead to battery
first then connect negative lead to engine foot.
bATTERY ACID CAN bURN EYES AND SKIN.
• Wear gloves and eye protection and be careful when
working near battery. Follow instructions printed on
battery.
the battery to the battery cables, the proper polarity
must be observed. Failure to observe the proper
polarity could result in damage to the charging cir-
cuit. The positive (+) battery cable has a red termi-
nal cover.
charger, disconnect the negative battery cable first
and then the positive battery cable before attaching
the charger leads. Failure to do so can result in
damage to the internal charger components. When
reconnecting the cables, connect the positive cable
first and the negative cable last.
D-3