Input Rectifier Bridge Removal And Replacement - Lincoln Electric PRO-CUT SVM146-A Service Manual

F-54

INPUT RECTIFIER BRIDGE REMOVAL AND REPLACEMENT

Service and repair should be performed by only Lincoln Electric factory trained personnel.
Unauthorized repairs performed on this equipment may result in danger to the technician or
machine operator and will invalidate your factory warranty. For your safety and to avoid elec-
trical shock, please observe all safety notes and precautions detailed throughout this manu-
al.
If for any reason you do not understand the test procedures or are unable to perform the
test/repairs safely, contact the Lincoln Electric Service Department for electrical trou-
bleshooting assistance before you proceed. Call 1-800-833-9353 (WELD).
DESCRIPTION
The following procedure will aid the technician in removing the input rectifier bridge for main-
tenance or replacement.
MATERIALS NEEDED
3/16" Allen type wrench
Phillips head screw driver
Torque wrench
Penetrox A13 (Lincoln E2529) Electrical Joint Compound
Dow Corning 738 (Lincoln E2861) Electrical Insulating Compound
This procedure takes approximately 16 minutes to perform.
TROUBLESHOOTING & REPAIR
WARNING
PRO-CUT 80
F-54