Functions In Diag Mode; Initial Settings Used To Start Diag; Input Change When Diag Menu Is Selected - Yamaha DSP-AX2700 Service Manual

•

Functions in DIAG mode

In addition to the DIAG menu items, functions listed below
are available.
• Input selection, Multi channel input
• Center/Rear/Rear center/Sub-woofer level adjustment
• Muting
• Power on/off
• Master volume
* Functions related to the tuner and the set menu are not
available.
* It is possible to confirm menu No.13 IF STATUS while
keeping the signal process (operation status) of each
DIAG menu by using the "AUDIO SELECT" key of the
main unit.
•

Initial settings used to start DIAG

The following initial settings are used when starting DIAG.
When DIAG is canceled, these settings are restored to
those before starting DIAG.
• Master volume: -20dB
• Input: DVD (MULTI CHANNEL INPUT OFF)
• Effect level: 0dB
• Audio mute: OFF
• Speaker setting: LARGE / BASS OUT = BOTH
• DIAG menu: DA70Y-YSS930 (1. MARGIN)
• Input change when DIAG menu is se-
lected
There are points where the input changes automatically
when DIAG menu is selected.
8. FL/OSD TEST: DVD
9. MANUAL TEST: DVD
13. IF STATUS: DVD
14. iPod: V-AUX/DOCK
15. Net: NET/USB
16. USB: NET/USB
17. PROTECTION HISTORY: DVD
RX-V2700/DSP-AX2700
25