Rear Panels - Yamaha DSP-AX2700 Service Manual

U, C, R, T, K, A, B, G, E, L models
C D
J model
C D
E (R, L models)
F
E F (U, C, R, T, A, B, G, E, L models)
F
E
Fig. 5
When checking the P.C.B.:
• Put the rubber sheet and the cloth over the equip-
ment. Then place the P.C.B.s upside down on the
cloth and check it. (Fig. 6)
• Reconnect all cables (connectors) that have been dis-
connected. Use the extension cable before servicing
the following section.
FL (1) P.C.B. CB953_D-VIDEO P.C.B. CB140:
MF120400 (10P, 350mm)
FUNCTION (1) P.C.B. CB410_A-VIDEO P.C.B. CB203:
MF117350 (11P, 70mm)
FL (2) P.C.B. CB957_D-VIDEO P.C.B. CB138:
MF115500 (15P, 500mm)
• When connecting the flexible flat cable, be careful
with polarity.
• In this unit, the ground of P.C.B.s shown below is con-
nected to the rear panel. When these P.C.B.s are re-
moved from the rear panel, connect the ground point
to the rear panel or chassis, using a ground lead or
such. (Fig. 6)
D-VIDEO P.C.B. ST101 (Ground)
D-VIDEO P.C.B. CB103 (HDMI IN2)
A-VIDEO P.C.B. PJ204 (COMPONENT VIDEO)
CB140
D-VIDEO P.C.B.
MF11500
CB138
CB957
MF120400
CB953
MF117350
FL (2) P.C.B.
Rear panel
CB410
FUNCTION (1) P.C.B.
RX-V2700/DSP-AX2700
D-VIDEO P.C.B.
A-VIDEO P.C.B.
Ground lead
CB203
A-VIDEO P.C.B.
Rubber sheet and cloth
Fig. 6
15