Table of Contents
Advertisement
b-20
STEEL AND STAINLESS SYNERGIC GMAW-P (PULSED MIG) WELDING
Synergic GMAW-P (Pulsed MIG) welding is ideal for low spatter, out of position and reduced heat input applica-
tions.
During pulse welding, the welding current continuously switches from a low level to a high level and then
back again. Each pulse sends a small droplet of molten metal from the wire to the weld puddle.
Pulse welding controls the arc length with 'Trim' instead of voltage. When trim (arc length) is adjusted, the Power
Wave automatically recalculates the voltage, current and time of each part of the pulse waveform for the best
result. Trim adjusts the arc length and ranges from 0.50 to 1.50, with a nominal value of 1.00 for a 3/4" (19mm)
electrode stick-out. Trim values greater than 1.00 increase the arc length, while values less than 1.00 decrease
the arc length.
Arc Length Short
ARC CONTROL
For steel and stainless pulse modes, Arc Control regulates the focus or shape of the arc. Arc Control values
greater than 0.0 increase the pulse frequency while decreasing the background current, resulting in a tight, stiff
arc best for high speed sheet metal welding. Arc Control values less than 0.0 decrease the pulse frequency while
increasing the background current, for a soft arc good for out-of-position welding.
A rc Con tr ol -10.0
Low Frequency, Wi de
OPERATION
FIGURE B.7a
Trim 1.00
Trim .50
Arc Length Medium
FIGURE B.7b
A rc Con tr ol OFF
Med ium Fr equency and Wi dth
POWER FEED™ 10M SINGLE WIRE FEEDER
Trim 1.50
Arc L ength Long
Arc Control +10.0
Hi gh Frequency , Fo cu sed
b-20
Advertisement
Table of Contents
