Pool Installation - Polygroup PRO-SERIES ABOVE GROUND RECTANGULAR QUICK SET Owner's Manual

Hide thumbs

Table of Contents

13. The pool is subject to wear and deterioration. If not maintained properly, certain types of excessive

or accelerated deterioration can lead to failure of the pool structure that might release large

quantities of water that could cause bodily harm and property damage.

14. Above ground / onground residential swimming pools are for swimming and wading only. No diving

boards, slides or other equipment are to be added to an above ground / onground pool that in any

way indicates that an above ground / onground pool may be used or intended for diving or sliding

purposes.

15. Never allow horseplay, diving or jumping into or around the pool. Serious injury, paralysis or death,

could result when this rule is disregarded. DO NOT ALLOW anyone to swim alone without supervision.

16. Safety signs shall comply with requirements of ANSI-Z535 and to use signal wording.

17. The pool is to be assembled by an adult; care should be taken in the unpacking and assembly of the

pool, this pool may contain accessible potentially hazardous sharp edges or sharp points that are a

necessary part of the function of the pool.

18. Become certified in cardiopulmonary resuscitation (CPR). In the event of an emergency, immediate

use of CPR can make a lifesaving difference.

19. Keep all electrical lines, radios, speakers and other electrical appliances away from the pool.

20. Do not place pool near or under overhead electrical lines.

21. Remove pool ladders before leaving the pool. Children as young as 2 years have climbed up ladders

and into pools and drowned.

NOTICE:

CUSTOMERS THAT PURCHASE POOLS MAY BE REQUIRED BY LOCAL OR STATE LAW TO

INCUR ADDITIONAL EXPENSES WHEN INSTALLING A POOL, IN ORDER TO COMPLY WITH STATE OR

LOCAL LAWS REGARDING FENCING AND OTHER SAFETY REQUIREMENTS. CUSTOMERS SHOULD

CONTACT THEIR LOCAL BUILDING CODE ENFORCEMENT OFFICE FOR FURTHER DETAILS.

CONSUMER AWARENESS BOOKLETS

Contact: U.S. Consumer Product Safety Commission at www.CPSC.gov/cpscpub/pubs/pool/pdf, Pub. #362

"Safety Barrier Guidelines for Home Pools" .

Contact: ASSOCIATION OF POOL & SPA PROFESSIONALS ( formerly NSPI) at-www.apsp.org/164/index.aspx

These titles are now available: "The Sensible Way To Enjoy Your Aboveground / Inground Swimming Pool" ,

"Children Aren't Waterproof" , "Pool and Spa Emergency Procedures For Infants' , Layers of Protection" , and

the "ANSI / NSPI-8 Model Barrier Code for Residential Swimming Pools, Spas, and Hot Tubs" .

Competent supervision and knowledge of the safety requirements

is the only way to prevent drowning or permanent injury

in the use of this product!

Never leave young children unattended.

DANGER: POOL SET-UP

Do not attempt to assemble this pool in adverse weather conditions, such as in high winds, strong gusts

or when the temperature is below 60°F.

Should you encounter any problems, contact the Customer Service at (888) 919-0070

from 8 AM to 5 PM Mon. thru Fri. EST. Extended operating days and hours during peak season requirements.

Compliments of www.poolsandstuff.com

DANGER:

RECTANGULAR FRAME POOL SETUP INSTRUCTION SHEET

WARNING -

VERY IMPORTANT! SITE MUST BE LEVEL, STABLE, COMPACTED SOIL.

• The pool must be assembled on a smooth and level site of firm soil that is free of stones, gravel, sticks,

blacktop or other oil base compounds. Do not install pool on a wooden deck or any type of wooden

surface. You can not use sand and/or uncompacted soil to provide a level surface for this pool; it will

only wash out.

• FAILURE TO FOLLOW THE INSTRUCTIONS BELOW WILL CAUSE POOL TO COLLAPSE AND WILL

VOID THE WARRANTY!

1. Select a level area, and completely remove all debris, twigs, stones, etc. DO NOT select an area under

overhead electrical lines, trees or within 15 feet of a house, building, etc. The area should also be at least

10 feet away, and no more than 21 feet away, from a 110 volt AC outlet, protected by a Ground Fault

Circuit Interrupter.

2. Contact your local utilities, checking that no underground cables, telephone lines, gas lines, etc. run

beneath the area you have selected.

WARNING: DO NOT

overfill the pool and / or allow people to lay over or sit on pool wall doing

so can cause permanent injury. DRAIN the pool to the proper level after a heavy rain.

TIP: It will be much easier to install your pool if you unfold it and let it lay in direct sunlight for about 2

hours prior to installation. This will help to insure a wrinkle-free fit because the pool material will be

more pliable allowing it to form into shape during installation.

1. Carefully unfold the Quick Set® pool and inspect seams for manufacturing defects. With the sleeve rim

on the top side, lay out the pool in the area selected, making sure the pool bottom is both flat and

rectangular-shaped. Position the power filter mounting area of the pool wall so that it is 10 to 21 feet

from the electrical outlet you

plan to use for the

pool pump. You

Swedged end

should have at least

three people to asist

Horizontal Beams

with the assembly

of this pool. Pull out

the rectangular flaps

of wall material

from the base of the

pool, (along each

end and on each side).

2. Locate the four metal (Corner Pieces) of pipe Fig. 1, then place one at every corner of the pool. Now

locate the (Horizontal Beams), insert a (O-Shape Spring) see Fig. 2 in each smaller swedged end of these

only to join the beams together in

length, Note: No O-Shaped Springs

are used in the Horizontal Beam

end attaching to the corner pieces

or in the corner pieces themselves,

please see the assembly drawing

page 5 for proper O-Shaped spring locations.

The (Horizontal Beams) for the pools ends are (the shorter ones) and (the longer ones) for the long

sides. Place half of the short ones on either (short end of the pool) and half of the long ones along each

(long side of the pool), these along with the (Corner Pieces) make up the support frame of the pool.

Begin by sliding the (Horizontal Beams) into the sleeve (making certain you work in a clockwise

SITE PREPARATION