Polygroup FunSicle QuickSet Pool Quick Start Manual

Ready. Set. Play.

This Quick Start Guide provides a simple overview to your pool's setup process.

For detailed setup guidelines, important safety information and useful tips, refer to the

enclosed "Funsicle QuickSet Pool User Guide."

STEP ONE:

Prepare the site.

Locate a clean and flat level area free of stones

or sharp objects.

TIP:

Let the liner sit under the sun for at least

two hours prior to installation; this allows the

liner material to be more flexible and ensure a

wrinkle-free fit.

STEP TWO:

Lay out the liner.

STEP THREE:

1. Inflate the air chambers following the numbered sequence (if any) slowly with a manual/foot

air pump. Use cold air only.

2. Check to confirm adequate air pressure. Your pool should be firm to the touch but not hard.

Do not overinflate. Refer to the enclosed User Guide for more information about air pressure.

3. Close and press the inflation valves into the unit to get a flat surface.

QuickSet Pool

Quick Start Guide

Inflate the top ring.

offers and discounts.

Scan the QR Code.

Table of Contents

Need help?

Do you have a question about the FunSicle QuickSet Pool and is the answer not in the manual?

Page 1 Ready. Set. Play. This Quick Start Guide provides a simple overview to your pool’s setup process. For detailed setup guidelines, important safety information and useful tips, refer to the enclosed “Funsicle QuickSet Pool User Guide.” STEP ONE: Prepare the site.
Page 2 2. Install the filtration system as per the enclosed “Funsicle Cartridge Filter Pump User Guide.” 3. Continue adding water to your pool and refer to the “Funsicle QuickSet Pool User Guide” for information and best practices about using, maintaining, draining, storing and/or winterizing your pool.