Ferroli ECONCEPT 100 Instructions For Use, Installation And Maintenance page 8

Adjustments
Setting the system temperature
To set the system delivery temperature on the single boiler shell, access the operational menu and press the
key to display parameter 1 – system delivery temperature. On pressing one of the keys
starts blinking and the delivery temperature setpoint is displayed. Use the keys
value. To activate the new setting, press
Summer/Winter selection
For the Summer/Winter selection, go to the operational menu and press
In relation to parameter "0.", pressing one of the keys
parameter "0." blinks); by using these same keys you can select Summer operation (set 00) or Winter operation
(set 11). To activate the new setting, press
In "Summer" mode (00) heating is off. The antifreeze function stays on.
Sliding Temperature
When the optional outside sensor is installed the generator adjustment system works with "Sliding
Temperature". In this mode, the temperature of the heating system is governed according to the weather
conditions outside so as to ensure a high degree of comfort and energy savings throughout the year. In
particular, as the outside temperature increases the system delivery temperature decreases according to a
specific "compensation curve."
With the Sliding Temperature adjustment, the temperature set in parameter 1 of the operational menu
becomes the maximum system delivery temperature. It is recommended to set a maximum value to permit
system adjustment throughout its useful working range.
The generator must be regulated at the time of installation by qualified personnel. Any adjustments can
anyhow be made by the user to improve comfort: the compensation curve can be modified from the
operational menu with the
The set compensation curve is displayed (cfr. graph beneath). On pressing one of the
starts blinking and it is possible again with the
press . To cancel, do not press the
If the room temperature is lower than as required, it is recommended to set a curve of a higher degree and
vice versa. Proceed by increasing or decreasing in steps of one and check the outcome in the room.
Compensation curves
90
80
70
60
50
40
30
20
8
key and scrolling through the menu again with the
key and press
20 10
. To cancel, do not press the key
displays the Summer/Winter selection (the
and to exit without activating the selection, press
to set the required value. To activate the new curve,
.
10
9
0
Outside temperature °C
ECONCEPT 100
, the display
to set the required
and press .
to display parameter "0.".
key to parameter 9.
keys, the display
7
8
-10 -20
.
6
5
4
3
2
1