Installation Procedure - Toshiba RAS-10SAVP-E Service Manual

Hide thumbs Also See for RAS-10SAVP-E:
Table of Contents

Advertisement

Toshiba ilmalämpöpumppujen myynti, huolto ja asennus: Jäähdytinpalvelu RefGroup Oy, Vantaa
10-1. Safety Cautions
140 mm or more
Air filters
2 Wireless
remote controller
100 mm or more
from wall
4 Remote controller holder
7 Remote controller
holder mounting screw
When installing the outdoor unit,
leave open in at least two of
directions (A), (B), (C) and (D)
shown in the figure below.
Before installing the wireless remote controller
• With the remote controller
cover removed, correctly load
the supplied batteries while
observing their polarity.
• Indoor units connectable with a multi-system outdoor unit (Other indoor units are unavailable.)
RAS-B10SKVP-E, RAS-B13SKVP-E, RAS-B16SKVP-E
• When using a multi-system outdoor unit, refer to the installation manual provided with the model concerned.

10. INSTALLATION PROCEDURE

Hook
Hook
5 Plasma pure filter
80 mm or more only
when unobstructed to
the front and both sides
50 mm or more
from wall
In principle,
leave open
(C)
200 mm
or more
(B)
Ensure sufficient space
to allow drainage
2 Wireless remote controller
www.ilmalämpöpumput.com
47 mm or more
1 Installation plate
Hook
74 mm
or more
6 Mounting screw
Z Shield pipe
(for extension
drain hose)
Y
(D)
(A)
250 mm or more
from wall
Power cord
Extension drain hose
(Option: RB-821SW)
Cover
3 Batteries
– 55 –
For the rear left and left piping
Wall
Insert the cushion between
the indoor unit and wall, and
tilt the indoor unit for better
installation work.
Do not allow the drain hose
to become slack.
Cut the piping hole
slightly sloped
Make sure the drain hose is
sloped downward.
The auxiliary piping can be
connected at the left, rear left,
rear right, right, bottom right or
bottom left as shown below.
Right
Rear
Bottom
right
left
Bottom right
Rear left
As shown in the figure, position
power cord and connecting cable
downward, and lead out along
piping connection port.
Insulate the refrigerant pipes
separately, not together.
6 mm thick heat resisting
polyethylene foam
Left

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents