Table of Contents
Advertisement
Main RF signal (black)
GSM TX : GSM Tx RF signal
GSM RX : GSM Rx RF signal
DCS TX : DCS Tx RF signal
DCS RX : DCS Rx RF signal
PCS TX : PCS Tx RF signal
PCS RX : PCS Rx RF signal
UMTS TX : UMTS Tx RF signal
UMTS RX : UMTS Rx RF signal
TX_I/Q : I/Q for Tx of RF
RX_I/Q : I/Q for Rx of RF
Control signal(red)
ANT_SEL 0,1,2 : Ant Switch Module Mode Selection
(WCDMA, GSM Tx/Rx, DCS Tx/Rx, PCS Tx/Rx)
GSM PA_CTL Signal
GSM_PA_BAND : DCS or PCS /GSM Mode Selection
GSM_PA_EN : Power Amp Gain Control Enable
GSM_PA_RAMP : Power Amp Gain Control
GSM/DCS/PCS_VCO_EN
GSM_TX_VCO_0_EN_N : GSM band Tx VCO Enable
GSM_TX_VCO_1_EN_N : DCS or PCS band Tx VCO Enable
UMTS PA_CTL Signal
TX_AGC_ADJ : WCDMA Tx Power Level Control
HDET1 : WCDMA Tx High Power Level Control
PA_ON : WCDMA Tx Power Amp Enable
W_VMODE_N : WCDMA Tx Power Amp Gain Control
TRK_LO_ADJ : TCXO(19.2M) Control
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 181 -
6. BLOCK DIAGRAM
LGE Internal Use Only
Advertisement
Table of Contents
