Program Tour; Call Tour - ATN TASC 336-7 Operator's Manual

3.1.6. PROGRAM TOUR

Tour is a function that camera could automatically move among
some presets according to a programmed route and dwell time after
calling it.
• Five tour(100,101,102,103,104) is available in this product.
• Each tour have 16 presets. If the presets are less than 16, the
last preset number should be set 119 ,then exit. If the presets
are more than 16, system will automatically save the former 16
presets. The dwell time must be set more than 3 seconds. If the
dwell time is less than 3 seconds, the system will automatically
set 3 seconds as default dwell time.
Case 1: Set the first tour which includes 5 presets. The number of
the five presets are 1 → 10 → 15 → 16 → 21, dwell time is 6 sec-
onds.
• Set preset 100 which corresponding to the first tour (please
refer the section about how to set preset)
• Set preset 6 which corresponding to the dwell time.
• Set preset 1 (the tour consists of preset 1)
• Set preset 10 (the tour consists of preset 10)
• Set preset 15 (the tour consists of preset 15)
• Set preset 16 (the tour consists of preset 16)
• Set preset 21 (the tour consists of preset 21)
• Set preset 119 (exist the tour programming)
• Press ACK and SHOT at the same time to exit setting status.

3.1.7. CALL TOUR

Call tour 1 by calling preset 100, Call tour 2 by calling preset 101,
call tour 3 by calling 102, call tour 4 by calling preset 103,call tour 5
by calling preset 104.
Case 2: The Tour 1, which have five presets in the order like 1 → 10
→ 15 → 16 → 21, and the dwell time of ever preset is six seconds,
was programmed.
Call preset 100 which corresponding to tour 1 (please refer the sec-
tion about how to call preset).
3-3