2.1. PREPARING FOR INSTALLATION
2.1.1. PREPARATION FOR USE
1. Basic requirement
• All electrical work should comply with the latest local electrical
regulation, fire precautions legislation and other relative legis-
lations and regulations.
• Check that whether accessories are complete or not according
to packing list. If not, please contact the seller.
• Make sure that the applied and installed place meets the
requirement of installation.
2. Check the structure of the applied and installed place
• Make sure that there is enough room to install this product and
its accessories.
• Make sure that the ceiling, wall and bracket which would install
this thermal speed dome should be able to endure as 4 times
weight as speed dome.
3. Set DIP switch
• Set DIP switch according to protocol, baud rate and speed
dome IP address .
• RS485 jumper setting.
4. Please keep all the safe packing material of thermal dome
Please keep the safe packing material of thermal dome after taking
apart the package. If there are some problems with the dome,
please pack with the original package and send it back to manu-
facturer.
NOTE
Non-original package will cause the unexpected damage
during transportation.
2.1.2. DIMENSION DRAWING
Appearance:
2-2
(Detailed information can be found in Appendix)