3.1. GENERAL INFORMATION
NOTE
These operating instructions cover the basic operation and
features of the dome.
3.1.1. SELF TEST
After the intelligent speed dome was powered on, the camera pan
and tilt automatically. And then it zoom from the nearest position
and stop in the farthest position. It could ensure that the speed
dome is in working order by self-testing.
3.1.2. CONTROL THE DIRECTION OF CAMERA
We should press the number of IP address of camera, and then
press SHOT key to call the camera to monitor, then we can make
thermal camera move up or down, left or right by moving joystick.
3.1.3. SCAN
Call preset 120 (Detailed information about how to call preset will
follow in this page) to start slow scan. Call preset 121 to start fast
scan.
3.1.4. SET PRESET
Press the ACK key and SHOT key in the keyboard at the same time
to enter setting status. Firstly, move the joystick to find a desired
preset position and focal length, then press the number key to enter
the preset number. Secondly, press SHOT key, then press ON key.
At last, press ACK key and SHOT key at the same time to exit set-
ting status.
3.1.5. CALL PRESET
Enter the preset number then press SHOT key to call the preset
wanted, then the camera will immediately move to the preset posi-
tion and automatically change to focal length of preset you called.
3-2