Table of Contents
Advertisement
6. Limit scan
To set the starting point of limit scan by using the limit start com-
mand in the control keyboard,then control the joystick to move to
the end point of limit scan with a certain speed. After calling the limit
scan, camera will automatically scan between the start and end
points with the speed which joystick moving.
7. Home point
Home place is a function that if there is no operation in a long time,
dome thermal camera would back to a certain important preset
place. Waiting time before home point function starting is from 1 to
255 second.
c. Features
TASC has the following important features:
• Advanced Thermal Detectors with resolution 336x256 or
640x515 pixels.
• High quality thermal image with 9/30/60 Hz frame rate.
• Built-in video analytics.
• Designed with low power consumption, standard 8 inch all-al-
loy housing.
• 360° horizontal continuous rotation. horizontal for 60°/sec;
vertical for 45°/sec.
• Support 128 preset positions, 5 tour routes.
• Against thunder and water, meet IP66 requirements.
• Support automatic reset when the preset has a wrong position.
• Periect used tool for middle range surveillance, even in total
darkness, light fog or smoke.
1.2.2. TECHNICAL PARAMETERS
Technical parameters of ATN thermal pan&tilt smart camera see
table below
1-7
Advertisement
Table of Contents
