Table of Contents
Advertisement
Operational Controls
Operational Controls
The twotwo series monitor is configured and controlled via a simple menu system which is viewed on the rear
panel display and navigated by four associated push-buttons. The first loudspeaker in the chain acts as the
master volume controller.
Looking at the four cursor buttons, the left and right buttons step back (exit) and select (enter) the menu
options, respectively, while the upper and lower buttons scroll through the various menu options and adjust
the parameter values. The menu structure is simple, logical and intuitive, and uses clear display legends to
indicate the selected function and parameter.
When the twotwo series monitor is connected to a mains supply it will power up in standby mode, and the
display will show 'Zzz'. Pressing any of the four rear panel buttons will turn the system on.
The factory default settings will initially configure the speaker to use the analogue XLR input source, with the
input sensitivity set to +12.5dB, Trim 0dB, all the equalisation set flat, backlight timeout 2 minutes, and the
volume set to -20.5dB. These factory default settings can quickly be restored by pressing and holding the Up
and Down buttons simultaneously for more than 2 seconds.
Default Display
With the loudspeaker switched on, the LCD window normally indicates the current volume level and the
selected input source.
The volume is indicated in decibels on the upper line of the display, within the range -48.5 to +15dB. To
increase or decrease the current volume level press the up/down buttons.
The selected input source is displayed on the second line of the LCD window, with the options of: analogue
XLR, analogue RCA-phono, AES3 left or AES3 right. The graphic below illustrates the default display, in this
case indicating a volume of -20.5dB and the analogue XLR input source.
V
o
l
u
A
n
a
l
Power Mode
By pressing the right (enter) button, the next menu level is accessed which accesses the power standby
mode. By pressing the right button again power standby is selected, and the LCD will show three Z charac-
ters to indicate the standby (Sleep) condition. The loudspeaker can be activated again by pressing any of
the rear panel buttons.
Z
z
z
m
e
–
o
g
u
e
2
0
.
5
X
L
R
d
B
Hide quick links:
Advertisement
Table of Contents
