3Com WL-560 User Manual page 26

20 C 2: I
HAPTER NSTALLING THE
B
RIDGE
Bridge Default Settings
Table 4 shows the Bridge configuration factory defaults.
Table 4 Factory Default Settings
Property
Device Name
Device Location
Country
Client Mode
IP Network Setting
IP Address
Subnet Mask
Gateway IP Address
Network Mode
Radio Mode
Wireless LAN Service Area
Channel Selection
Transmit Power
Antenna Selection
Data Preamble
Security Setting
802.1x Authentication State
SNMP
Access Control List
Administration Login Name
Administration Password
TFTP Server IP Address
FTP Server IP Address
Default Setting
3Com WWB
None (blank)
For U.S. version, United States and Canada
For non-U.S. version, set by the user
Support multiple wired Ethernet clients
Obtain IP address automatically
Obtained automatically (with a DHCP server)
169.254.2.2 (without a DHCP server)
Obtained automatically (with a DHCP server)
255.255.0.0 (without a DHCP server)
Obtained automatically (with a DHCP server)
0.0.0.0 (without a DHCP server)
Wireless Client (Infrastructure)
Auto Select
Attach to any WLAN Service Area (ESSID) automatically
Automatic Best Channel (uses access point setting)
100%
Internal
Long (if Network Mode is set to Ad-Hoc)
Same as access point setting (if Network Mode is set
to Wireless Client [Infrastructure])
Open System (no security)
Disabled
Enabled
Disabled
admin
None (blank)
None
None