Location - Scotsman F0522 Installation And User Manual

N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
D Series Air, Water or Remote User Manual

Location:

While the machine will operate satisfactorily within the
listed air and water temperature limits, it will produce
more ice when those temperatures are nearer the
lower limits. Avoid locations that are hot, dusty, greasy
or confined. Air cooled models need plenty of room
air to breathe. Air cooled models must have at least
six inches of space at the back for air discharge;
however, more space will allow better performance.
Airflow
Air flows into the front of the cabinet and out the back.
The air filters are on the outside of the front panel and
are easily removed for cleaning.
Airflow
Options
Side air flow kits KPFSA223 or KPFSA227 are
available for air cooled models. A filter kit for the
remote condenser is KERCF
Ice is made until it fills the bin enough to block an
infrared light beam inside the base of the machine. A
field installed kit is available to adjust the maintained
ice level lower. The kit number is KVS.
The standard controller has excellent diagnostic
capabilities and communicates to the user through the
AutoAlert light panel, seen through the front panel.
Field installed kits are available that can log data and
provide additional information when the front panel is
removed. The kit numbers are KSBU and KSB-NU.
See page 21.
Bin compatibility
All models have the same footprint: 22 inches wide
by 24 inches deep. Confirm available space when
replacing a prior model.
Bin & adapter list:
• B322S – no adapter needed
• B330P or B530P or B530S – Use KBT27
• B842S – KBT39
• B948S – KBT38 for single unit
• B948S – KBT38-2X for two units side by side
• BH1100, BH1300 and BH1600 upright bins include
filler panels to accommodate a single 22 inch wide
ice machine. No adapter is needed.
Dispenser compatibility
Only nugget ice models may be used with ice
dispensers. Flaked ice is not dispensable.
• ID150 – use KBT42 and KDIL-PN-150, includes
KVS, KNUGDIV and R629088514
• ID200 – use KBT43 and KNUGDIV and KVS
• ID250 – use KBT43 and KNUGDIV and KVS
See sales literature for other brand model ice and
beverage dispenser applications.
Other Bins & Applications:
Note the drop zone and ultrasonic sensor locations in
the illustrations on the next pages.
Scotsman ice systems are designed and
manufactured with the highest regard for safety
and performance. Scotsman assumes no liability of
responsibility of any kind for products manufactured
by Scotsman that have been altered in any way,
including the use of any part and/or other components
not specifically approved by Scotsman.
Scotsman reserves the right to make design changes
and/or improvements at any time. Specifications and
design are subject to change without notice.
October 2014
Page 3