Plantronics Vista M12 User Manual page 8

install
1
S T E P
b a t t e r i e s
The Vista Amplifier requires power
to work with most phones.
1. Remove the Battery Access Door located on
the side of the amplifier by placing your
thumb on the door and pushing down.
2. Install two AA alkaline batteries and
replace the door.
3. You will hear three "beeps" through the
headset when the batteries are low.
2
I N S T A L L A T I O N S T E P S
S T E P
1. Unplug your telephone's handset cord
2. Plug your telephone's handset cord into
3. Connect your telephone base to the
4. Plug the headset cord into the Quick
e n g l i s h
I N S T A L L A T I O N S T E P S
attach to
2
p h o n e a n d h e a d s e t
from the telephone base.
the Vista amplifier handset jack ( ).
Vista amplifier telephone jack ( ) using
the short curly cord. On your telephone
base, plug the short curly cord into the
outlet normally used for your handset.
Disconnect ™ (QD) module on the long curly
cord coming from the front of the amplifier.
The QD will allow you to disconnect the
headset from the amplifier when you
are not using the phone, or need to
move away from the amplifier, while
leaving your headset in place.
e n g l i s h 3