Technical Data; Declaration Of Conformity; Battery Charging - Bosch GKS 18 V-LI Professional Original Instructions Manual

OBJ_BUCH-755-002.book Page 23 Friday, July 11, 2008 9:50 AM

Technical Data

Circular Saw
Article number
Rated voltage
No-load speed
Cutting depth, max.
– for 0° bevel angle
– for 45° bevel angle
Spindle lock
Base plate dimensions
Saw blade diameter,
max.
Saw blade diameter,
min.
Blade thickness, max.
Tooth thickness/set-
ting, max.
Tooth thickness/set-
ting, min.
Mounting bore
Weight according to
EPTA-Procedure
01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Bosch Power Tools
Dr. Egbert Schneider
Senior Vice President
Engineering
GKS 18 V-LI
Professional
3 601 F6H 0..
V= 18
11.04.2008, Robert Bosch GmbH, Power Tools Division
-1 D-70745 Leinfelden-Echterdingen
min 3900
mm 51
Assembly
mm 40

Battery Charging

mm 146 x 272
mm 165
mm 160
Note: The battery is supplied partially charged.
mm 1.7
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
mm 2.6
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
mm 2.0
ing the charging procedure does not damage the
mm 20
battery.
The Li-ion battery is protected against deep dis-
charging by the "Electronic Cell Protection
kg 4.1
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
chine has been automatically switched off. The
battery can be damaged.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Observe the notes for disposal.
Dr. Eckerhard Strötgen
Head of Product
Certification
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Do not continue to press the
WARNING
On/Off switch after the ma-
2 609 932 639 | (11.7.08)
English | 23