Accessories; Options/Accessories; Field Installed Options; Stick Welding Accessories - Lincoln Electric COMMANDER SVM145-B Service Manual

C-2

OPTIONS/ACCESSORIES

The following options/accessories are available for
your Commander 300 from your local Lincoln
Distributor.

FIELD INSTALLED OPTIONS

K802R POWER PLUG KIT - Provides a plug for each
receptacle.
K857 25 ft. (8.5 m) or K857-1 100 ft. (30.4 m)
REMOTE CONTROL - Portable control provides same
dial range as the output control on the welder from a
location up to the specified length from the welder. Has
convenient plug for easy connection to the welder. The
Commander 300 is equipped with a 6-pin connector for
connecting the remote control and a toggle switch for
selecting "LOCAL" output control or "REMOTE" output
control.
K704 ACCESSORY SET - Includes 35 feet (10 m) of
electrode cable and 30 feet (9 m) of work cable, head-
shield, work clamp and electrode holder. Cable is rated
at 500 amps, 60% duty cycle.
K953-1 TWO-WHEEL TRAILER - For road, in-plant
and yard towing. Road towing with optional fender and
light kit. (For highway use, consult applicable federal,
state and local laws regarding possible additional
requirements.)
• K953-1 Trailer
• K958-1 Ball Hitch
• K958-2 Lunette Eye Hitch
• K959-1 Fender & Light Kit
• K965-1 Cable Storage Rack
K887-1 ETHER START KIT - Provides maximum cold
weather starting assistance for frequent starting below
10( F (-12.2( C). Required Ether tank is not provided
with kit.
K1604-1 OIL DRAIN KIT - Includes ball valve, hose
and clamp.
K1690-1 (2 DUPLEXES) GFCI KIt - Includes a UL
approved 115 volt ground fault circuit interrupter recep-
tacle (duplex type) with covers and installation instruc-
tions. Each half of the receptacle is rated 15 amps, but
the maximum total current from the GFCI duplex is lim-
ited to 20 amps. The GFCI receptacle replaces the
factory installed 115 volt duplex receptacle.
S24647 SPARK ARRESTER

ACCESSORIES

K1596-1 DUAL OUTPUT METERS AND GAUGES -
Dual output meters provide preset ability of voltage for
wire welding and current for stick welding. Measures
both current and voltage when welding.
include battery ammeter, engine temperature, and
engine oil pressure. Fuel gauge is not available in kit
form.
K1597-1 42 VAC TRANSFORMER KIT - For products
requiring 42 VAC power source.

STICK WELDING ACCESSORIES

K704 Accessory Kit, which includes:
• Electrode holder and cable.
• Ground clamp and cable.
• Headshield.

TIG WELDING ACCESSORIES

Magnum TIG Torch
•
• Magnum Parts Kit and Argon gas
• K930-ALL TIG Module (not required for
scratch-start DC TIG welding)
• K936-1 Control Cable
• K870 Foot Amptrol
Also available:
• K963-1/-2 Hand Amptrol
• K814 Arc Start Switch
• K937-22 Control Cable Extension
• K937-45 Control Cable Extension
• K844-1 Water Valve
COMMANDER 300
C-2
Gauges