Table of Contents
Advertisement
Lens position setup and focus adjustment
Lens position setup (Using projector functions)
Automatically return the lens to base position using the projector.
* The menu screens shown in these operating instructions are only provided as examples. Actual menu screens
may vary with the specific model.
*1: See software download page on Panasonic website (http://panasonic.net/avc/projector/pass/). You must be a
registered PASS user to use the site described above.
* PASS: Panasonic Professional Display and Projector Technical Support Website
8-ENGLISH
1) Turn on the projector to start the
projection.
2) Press the <MENU> button to open
the [MAIN MENU] screen. Then select
[PROJECTOR SETUP] and press the
<ENTER> button.
3) Select [SERVICE PASSWORD] in the
[PROJECTOR SETUP] menu and press
the <ENTER> button.
4) In the [SERVICE PASSWORD] entry
screen, enter "7590" using the numeric
buttons on the remote control and then
press the <ENTER> button.
zThe [D75LE90 POSITION] screen appears.
5) Press the <ENTER> button in the [D75LE90
POSITION] screen.
z[PROGRESS] is displayed on the [D75LE90 POSITION]
screen and lens position moves to the standard projection
position for the ET-D75LE90.
Note
z Lens position can also be set using the supplied lens shift
gauge (
Page 9).
z The [MAIN VERSION] of the projector firmware must be the
version noted below in order to set the lens position using the
function on the projector. Check the [MAIN VERSION] of the
firmware on the [STATUS] screen and upgrade the firmware
version of the projector as needed. *
Projector
PT-DZ21K / PT-DS20K / PT-DW17K
PT-DZ16K
PT-DZ13K / PT-DS12K /
PT-DW11K / PT-DZ10K
Projector other than one listed above
*Only projectors that this lens is compatible with.
[STATUS] screen is displayed by selecting [Main Menu]
→ [PROJECTOR SETUP] → [STATUS] or by pressing the
<STATUS> button on the remote control.
1
Main version
4.02 or higher
1.04 or higher
4.04 or higher
1.00 or higher
Advertisement
Table of Contents
