Attaching The Lens; Detaching The Lens - Panasonic ET-D75LE90 Operating Instructions Manual

Attaching the Lens / Detaching the Lens (continued)

Attaching the Lens

(i)
(ii)
(i)
(i)
Lens drop
prevention
screw

Detaching the Lens

(i)
(ii)
(i)
Lens
release
button (i)
*1: Only when using a projector that has a projection lens cover.
In addition, there are cases where the attachment method or
removal method of the projection lens cover differs from the
procedure (illustration) described above depending on the model
being used. For details, see "Attaching/removing the projection
lens (optional)" in the operating instructions for the projector
you are using.
(i)
Projection
lens cover
(i)
Orange color
(ii)
(i)
Projection
lens cover
(i)
Orange color
(ii)
(iii)
* The illustration for this procedure uses PT-DZ21K
as an example.
1) Remove the projection lens cover.*
2) Align the mark on the projection
lens (orange color) with the mark
on the projector (O on the left
side of the LOCK) and insert; then
rotate in a clockwise direction
until it makes a "click" sound.
3) Secure the projection lens with
the lens drop prevention screw
included with the projector.
z Secure it in the screw hole (location shown in the
figure to the left) on the right side of the projection
lens mark (orange color) using a Phillips screwdriver.
4) Attach the projection lens cover.*
Attention
z Gently turn the projection lens counterclockwise
to check that it will not fall out.
* The illustration for this procedure uses PT-DZ21K
as an example.
1) Remove the projection lens cover.*
2) Remove the lens drop prevention
screw.
zRemove the first screw on the right side of the
projection lens mark (orange color) using a
Phillips screwdriver.
3) Turn the projection lens
counterclockwise while holding
down the lens release button to
take it off.
zTurn counterclockwise until the projection lens
mark (orange color) is aligned with the mark on
the projector (O on left side of the LOCK).
4) Attach the projection lens cover.*
Attention
z Store the projection lens that was removed while
avoiding vibration and impact.
z Store the lens drop prevention screw that was
removed and do not lose it.
z Attach the supplied lens cap before storing the lens.
1
1
1
1
ENGLISH-5