Lincoln Electric CLASSIC 11572 Operator's Manual page 28

Lincoln electric welder user manual
Table of Contents

Advertisement

E-7
PRObLEMS
(SYMPTOMS)
White or Blue Smoke.
Dark Grey Smoke.
Faulty Charging.
Starter Motor does not run.
Engine Protection Light not com-
ing on.
No Auxiliary Power
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
TROubLEShOOTING
Observe all Safety Guidelines detailed throughout this manual
POSSIbLE
1.
Excess engine oil.
2.
Too low viscosity of the
engine oil.
3.
Faulty injection timing.
1.
Unsuitable fuel.
2.
Excess injection.
3.
Faulty function of the engine.
4.
Overloading.
5.
Clogged air cleaner.
1.
Loose fan belt.
2.
Faulty wiring.
3.
Faulty battery.
4.
Worn out alternator brush.
1.
Loose or damaged wiring.
2.
Drained voltage from battery.
3.
Damaged
(including solenoid).
1.
Broken Light Bulb.
2.
Faulty light wiring.
3.
Faulty Engine Control Unit.
1.
Open circuit breakers.
Reset breaakers.
2.
GFCI module may have
tripped.
Follow "GFCI Module Testing
and Resetting Procedure" in
the Maintenace Section of this
Manual.
3.
Faulty connections to auxiliary
receptacles.
Check connections
CLASSIC® 300D PERKINS
CAuSE
starter
motor
If all recommended possible areas
of misadjustment have been
checked and the problem persists,
Contact your local Lincoln
Authorized Field Service Facility.
CAuTION
RECOMMENDED
COuRSE OF ACTION
E-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Classic 300 d perkins

Table of Contents