HP ProLiant DL160 Gen9 User Manual page 76

To install the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 19).
o
If installed, remove the security bezel
4.
Remove the access panel (on page 20).
5.
Remove the blank from the front panel. Retain the screw for USB module installation.
6.
Install the USB 3.0 module into the front panel and secure it with the screw.
7.
("Remove the security bezel (optional)" on page 20).
Hardware options installation 76