Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha Raptor 90 YFM90RA 2011 Service Manual

IMPORTANT INFORMATION
EBS00016
LOCK WASHERS/PLATES AND COTTER
PINS
After removal, replace all lock washers/plates
and cotter pins. After the bolt or nut has
been tightened to specification, bend the lock
tabs along a flat of the bolt or nut.
EBS00017

BEARINGS AND OIL SEALS

Install bearings and oil seals so that the manu-
facturer's marks or numbers are visible. When
installing oil seals, lubricate the oil seal lips
with a light coat of lithium-soap-based grease.
Oil bearings liberally when installing, if appro-
priate.
Oil seal
NOTICE
Do not spin the bearing with compressed
air because this will damage the bearing
surfaces.
Bearing
EBS00018

CIRCLIPS

Before reassembly, check all circlips carefully
and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip
sharp-edged corner
the thrust
Shaft
1 - 3
GEN
INFO
, make sure the
is positioned opposite
that the circlip receives.