Table of Contents
Advertisement
Chapter 3 Settings
Connect the camera to the control device or control software. control device,
including controlling keyboards and hard disk recorders, and control software, which
designed for the clients, can be used to change camera settings. See also the user
manual to grasp the specific operations.
3.1 Keyboard Controller
Follow the following steps to use the controller setting the camera menu.
1
Call the preset position No.95, open the camera setting screen.
2
Use the stick to browse the menu.
3
Press the "Iris on" button to open the menu; One can also use the stick to open this menu.
4
Use the stick to change chosen parameters.
5
Press the button "Iris on" to apply the change.
3.2 Self-Checking Information
The dome camera operates self-checking moves after being set up a electric circuit. First
horizontally, then vertically, at last the camera-moves. The starting up image would be shown on
the screen after the self-checking moves are done, which vanishes 30 seconds after the start-up.
Horizontal Moves: The dome camera moves downwards to the vertical direction, then upwards to
the preset position before it was set up to the electric circuit.
Vertical Moves: The dome camera moves downwards to the vertical direction, then upwards to the
position before it was set up to the electric circuit.
Camera-moves: Limit-zoom-out the camera lens, then returns and stays at the zoom multiple
before it was set up to the electric circuit.
3.3 OSD Menu Tree
17
Advertisement
Table of Contents
