Panasonic NV-GS24EG Service Manual page 48

NV-GS24EG NV-GS26GK / NV-GS27E NV-GS27EB / NV-GS27EE NV-GS27EF / NV-GS27EG NV-GS27EP / NV-GS27GC NV-GS27GN / NV-GS37E NV-GS37EB / NV-GS37EG NV-GS37EK / NV-GS37EP NV-GS47
/ NV-GS47GC NV-GS57EE / NV-GS57GC NV-GS58GK
14. Installation of LCD Panel, Reflect Sheet, Lead Light
Panel, Diffusion Sheet, BEF Sheet, BEF Sheet A and
Panel Holder Unit
a. When replacing the LCD Panel, the Diffusion Sheet,
the BEF Sheet and the BEF Sheet A, make sure to
remove the Protection Sheets.
To distinguish Sheets from attached Protection
Sheet:
- A blue Protection Sheet is affixed to both faces of the
Diffusion Sheet.
- A yellow Protection Sheet is affixed to both faces of
the BEF Sheet.
- A green Protection Sheet is affixed to both faces of the
BEF Sheet A.
Protection Sheet
(blue)
Protection Sheet
(yellow)
Protection Sheet
(green)
b. Use extreme care when handling the LCD Panel, the
Reflect Sheet, the Lead Light Panel, the Diffusion
Sheet, the BEF Sheet and the BEF Sheet A to avoid
damage, dust, and spots (especially fingerprints, etc.)
Install in order shown below.
1) Install in order, the BEF Sheet A, BEF Sheet and
Diffusion Sheet while inserting the corners of each
sheet into the slots of the Panel Holder Unit.
2) Install the Lead Light Panel while inserting the corners
into the slots of the Panel Holder Unit.
3) Place the Reflect Sheet so it is aligned with the edge
of the Panel Holder Unit, then install it using the
adhesive tape portions of the Reflect Sheet.
Panel Holder Unit
4) Install the LCD Panel with adhesive tape so that the
cross marks are positioned in the center of the holes in
the Panel Holder Unit.
Diffusion Sheet
BEF Sheet
BEF Sheet A
Adhesive
Reflect Sheet
tape
Do not touch
the surface of
Lead Light Panel.
Fig. D15-1a
Reflect Sheet
Lead Light Panel
Diffusion Sheet
BEF Sheet
BEF Sheet A
(L-5)
Panel Holder Unit
View A
adhesive
tape
hole
cross mark
hole of Panel
Holder Unit
48
adhesive
tape
(white)
(stripe)
(stripe)
slot
slot
hole
adhesive
tape
cross mark
LCD Panel
cross mark
cross mark
hole of Panel
View A
Holder Unit
Fig. D15-2a