Removal Procedure For Electronic Controller
1 Remove indicador complete
Afer removing the front grille, loose the screw behind the indicator,
the whole indicator can be released.
2 Remove the cover of control board and holder
3 Break off the earing ,release the holder slightly.
Be sure to avoid cracking of the holder.
4. Release the lead wire CN-FM, CN-VF, CN-STM, CN-DISP and
earth wire(Yellow/Green). Take out the sensor from the socket.
Pull out the whole electronic controller.
5. Remove the whole control board
Loose the screw s of control board,earings slightly, then the whole
control board can be pulled out.
Removal Procedure For the Discharge Grille
1. Separate the drain hose and the drain plate(Fig.10)
2. Pull out the discharge grille slightly (Fig. 11)
Fig 6
Fig 7
Fig 8
Fig 9
Fig 10
51
CS-PW9DKE / CU-PW9DKE / CS-PW12DKE / CU-PW12DKE
Indicator Complete
Earing
Holder
Fig. 11