Sirius Satellite Radio Stiletto 2 Installation And User Manual page 45

REMOVE REMOVE
ADHESIVE BACKING ADHESIVE BACKING
FROM ARROW FROM BEAD
c.~)~
HEMaVE BOTHtSUCl,aN CUPS -----------(_;')
lr - . , "
f.c!
l
f-t~".
- ' - . j / '
~
, ..
j - . - ' "
I /
e
L
THIS TH!NNER parmON OF THE FEA SHOULD BE
~
USE THE CABLE GUIDES TO HOLD THE CABLE IN POSITION
TAUT WHEN THE FEA IS PERMANENTLY ADHERED UNTIL IT REACHES THE INNER TRIM OR MOULDING
Figure 30
Step 9: Route and hide the cable through the vehicle to
your SIRIUS radio
Hide most of the cable by properly routing the antenna cable to your SIRIUS radio. (Figure
31) Use the cable guides to hold the cable in place until it reaches the inner trim or moulding
at the edge of the window. Take advantage of any existing cable channel or wiring conduit
and route the cable around the passenger compartment to the vehicle dock. Take care not
pull the cable across sharp edges that could damage it, and keep it away from areas where it
might entangle feet. Coil and secure any excess antenna cable in a location where it can be
hidden and secured (such as under the carpet or floor mat). Make sure the FEA is plugged
into the FM OUT connector of the radio or vehicle dock.
Figure 31
This completes the FEA installation.
[ Installation]
45