Sirius Satellite Radio Stiletto 2 Installation And User Manual page 28

front of the vehicle. Use a plastic putty knife to lift the plastic trim just enough to tuck
the cable under underneath. Avoid side airbag locations on back pillars and above the
doors. (Airbag locations are marked with "SRS" logos.) Be careful not to crimp or cut
the cable.
3. Bring the cable out from the trim near the firewall and route it under the carpet toward
the dashboard or console. Coil any excess cable in a hidden location, such as under the
carpet, keeping it away from any vehicle pedals or controls. Secure the excess cable
with wire ties.
4. Bring the end of the cable out at the SIRIUS radio location. Leave yourself enough cable
so you can easily connect it to the antenna connector of the SIRIUS radio or vehicle
cradle/dock.
Convertible Antenna Cable Routing Procedure
Fi~lure
14 shows how the antenna cable should be routed from the antenna to your SIRIUS
:;lch' In a
convertible.
6. Bring Cable Out To
Docking Station
Location and Connect
/ to the Docking Station
/
//
3. Tie Cable to Hinge Strut, Allowing
Slack for Lid to Open and Close.
Route Cable Into Cabin
Through Existing Wire
Channel.
5. Bring Cable out from
... Trim and Route Under
\ - - - - - - - _ " / Carpet to Dashboard ....
{
f1 ':
or Console.
#--, ,/ /
.
.....
-.....
","'''
" ' .
" --;
\
/
l;' ,," 1,'/
,,'
~
"
(,/'
\ -' ' " 4. Route Cable from Trunk
\
~
Under Interior Trim, into
\ Cabin and Towards Front
I
of Vehicle
i
\
\
2. Tape Cable Along
Inside of lid to
Hi nge Strut
1.
Bring Cable from
Antenna Into Inside
of Trunk Lid '.,
"
"-
' ' ' ' "
Figure 14
~28
[ "1""
a'!
-:>
~
•
~
'\ ]
I ,::).
":1..1',)0,