Pc Input Signal Reference Chart - Sony Bravia KDL-52XBR7 Operating Instructions Manual

PC
Use the TV as a monitor for your PC by connecting a HD
J
S-HD IS cable as shown below. This TV can
also be connected to a PC with a DVI or HDMI output. (Refer to the separate Quick Setup Guide.)
Rear of TV
_ HD15-HD15
cable (analog
RGB)
Audio cable (stereo mini plugs)
L----===:::::::::...
,l ---'
{b
• Connect the PC IN jack to the PC using an HD 15-
HD 15 cable with ferrite core (analog RGB) and audio
cable (see page Il).
• If the PC is connected to the TV and no signal has been
input from the PC for more than 30 seconds. the TV
enters the standby mode automatically (see page 52).
VGA
VESA
VGA-T
Standard
75
70
60
Vertical
fre
'Y
(Hz)
31.5
x
x
x
PC Input Signal Reference Chart
After connecting the PC to the TV, set the output signal from the PC according to the supported resolutions
and timings indicated below.
,t!~
SVGA
XGA
WXGA
{b
• This TV's PC input does not support Sync on Green or
Composite Sync.
• This TV's PC VGA input does not support interlaced
signals.
• Your PC must support one of the above PC input
signals to display on the television.
• For the best picture quality. it is recommended to use
the signals (boldfaced) in the above chart with a 60 Hz
vertical frequency. In plug and play, signals with a 60
Hz vertical frequency will be detected automatically.
(PC reboot may be necessary.)
*
The 1080p timing when applied to the HDMI input will
be treated as a video timing and not PC timing. This
affects Picture settings, Wide Mode settings. and PIP
function. To view PC content set Picture Mode to
Custom, Wide Mode
to
Full. and Display Area
to
Full Pixel.
14