Bolt VX-760N User Manual page 40

Setting the slave mode: To set the VX-760N flash unit to
function as an automatic slave, follow these steps:
1. Make sure the master flash or controller on your camera is
on and set to automatic TTL or wireless manual mode.
2. Press and hold the MODE button until the wireless flash
mode icon ( ) and the channel and group settings appear
on the LCD.
3. Set the channel by pressing the SUB button to make the
channel number blink. Use the left and right navigation buttons to cycle through channel numbers 1–4.
When the desired channel number appears on the LCD, press the MODE button to select it.
4. Set the group by pressing the SUB button until the group letter blinks. Use the left and right navigation
buttons to cycle through groups A–C. When the desired group appears on the LCD, press the MODE button
to select it.
5. If desired, adjust the zoom position by pressing the ZOOM button (see Controlling Flash Coverage on
page 27).
Note: The wireless ready indicator light will blink in slave mode.
| |
40 40 Using Your VX-760N as a Wireless Master or Slave
Zoom