Sanden GAUS-315EQTD Installation Manual page 32

Fix the tank unit in place with anchor bolts if necessary.
The floor below the tank has been properly water proofed and is capable of
supporting the tank.
The mains breaker is of the correct size and voltage Breaker can be turned off,
local disconnect in place.
Ground wiring is installed and tight.
The Heat Pump unit is installed on a level sturdy surface.
There are no gas containers or flammable materials anywhere near the unit.
The wiring between the tank unit and the heat pump unit is properly connected.
Around units
A concrete base block is installed (if necessary).
An inspection space is retained in accordance with the installation manual
Around the piping
Dedicated water shut off valves are installed.
The piping for the water supply/hot water supply pipe has been properly
insulated.
There is no water leaking from the water supply/hot water supply and heat
pump pipes.
In areas subject to snap freezes, protection is provided – Heat Tape, insulation
etc
Union joints are used so that the parts can be easily removed.
Piping is installed from the drain outlet and drain pan to a building or area
where condensate cannot freeze and pose a slip hazard.
The filter in the pressure-reducing valve is clean.
Independent pipes, not a twin tube, are used for the heat pump unit pipes.
The drainage hose from the heat pump unit leads into a building drain or area
for disposal.
Insulation is provided for the water supply/hot water supply and heater pump
pipes.
During draining of the tank unit water does not overflow from the building drain.
Installed By..........................................
Inspected By .......................................
Action
Action
Action
Sanden Heat Pump – Installation Manual
Page 32 of 33
Date.......................................
Date.......................................
Completed
Completed
Completed