Table of Contents
Advertisement
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs
when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually correct it following one of
these steps.
•
Using the remote control
Press
/
on the projector or remote control to display the Keystone
correction page. Press
to correct keystoning at the bottom of the image.
•
Using the OSD menu
1.
Press MENU/EXIT and then press
highlighted.
2.
Press
to highlight Keystone and press MODE/ENTER. The
Keystone correction page is displayed.
3.
Press
to correct keystoning at the top of the image or press
correct keystoning at the bottom of the image.
•
You can correct the vertical keystones. However, their adjustment ranges are
limited in such correction.
•
When the keystone adjustment is carried out, the adjustment value is indicated.
Note that this value doesn't mean a projection angle.
•
The allowable range of the adjustment value in the keystone adjustment varies depending on the installation conditions.
•
Images may not be projected in a shape of a regular rectangle or with its aspect ratio 4:3 (EX320U)/16:10 (EW330U),
depending on the installation conditions of the projector and the screen.
•
When the keystone adjustment takes effect, the resolution decreases. In addition, stripes may appear or straight lines may
bend in images with complicated patterns. They are not due to product malfunctions.
•
Noise may appear on the screen during the keystone adjustment because of the type of the video signal being projected
and the setting values of the keystone adjustment. In such cases, set the keystone adjustment values in the range where
the image is displayed without noise.
•
When the keystone adjustment is carried out, the image may not be displayed correctly because of the type of input
signal.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for
navigating the picture.
•
Using the remote control
1.
Press MAGNIFY +/- to display the Zoom bar.
2.
Press MAGNIFY + to magnify the center of the picture. Press the key
repeatedly until the picture size is suitable for your need.
3.
Use the directional arrows ( ,
control to navigate the picture.
4.
To restore the picture to its original size, press AUTO. You can also
press MAGNIFY -. When the key is pressed again, the picture is further
reduced until it is restored to the original size.
•
Using the OSD menu
1.
Press MENU/EXIT and then press
2.
Press
to highlight Magnify and press MODE/ENTER. The Zoom bar is displayed.
3.
Repeat steps 2-4 in the section of
panel, continue to the following steps.
4.
Press
on the projector repeatedly to magnify the picture to a desired size.
5.
To navigate the picture, press MODE/ENTER to switch to the panning mode and press the directional arrows
( ,
,
,
6.
Use the directional arrows ( ,
7.
To reduce size of the picture, press MODE/ENTER to switch back to the zoom in/out functionality, and press
AUTO to restore the picture to its original size. You can also press
original size.
The picture can only be navigated after the picture is magnified. You can further magnify the picture while searching for details.
EN-26
to correct keystoning at the top of the image. Press
/
,
,
/
"Using the remote control"
) to navigate the picture.
,
,
until the DISPLAY menu is
to
) on the projector or remote
until the DISPLAY menu is highlighted.
above. Or if you are using the projector control
) on the projector or remote control to navigate the picture.
/ .
Press
repeatedly until it is restored to the
/
Press
Hide quick links:
Advertisement
Table of Contents
