Connecting the stand
- Only on some models.
1
Place a soft cloth on the table and put the
product with the screen facing downward.
Connect the stand as shown in the following
picture.
2
Use the screws to secure the stand on the rear
side of the product as shown in the diagram.
ASSEMBLING AND PREPARING
Using the IR Receiver
This allows a remote control sensor to be placed
in a custom location. Then that display can control
other displays via an RS-232C cable. Install the IR
receiver towards the front of the set.
IR Receiver cable
NOTE
y
When you see from the back of the set, if
the IR receiver cable does not face front, the
signal reception range may shorten.
y
The IR receiver is made with a magnet.It is
detachable at the bottom (typical installation)
or back (wall installation) of the set.
y
Make sure the power cable is disconnected.
9