Toshiba TECRA S5 User Manual page 85

Connecting
1. Make sure the connectors are properly aligned and plug the i.LINK
2. Plug the other end of the cable into the device.
Note the following when you use i.LINK:
■
■
■
■
Disconnecting
1. Open the Safely Remove Hardware icon on the Task Bar.
2. Point to i.LINK (IEEE1394) device and click.
3. Disconnect the cable from the computer then from the i.LINK device.
Refer also to the documentation that came with your i.LINK device.
Downloaded from LpManual.com Manuals
User's Manual
(IEEE1394) cable into the computer.
i.LINK (IEEE1394)
port
Figure 3-13 Connecting the i.LINK (IEEE1394) cable into the computer
You may need to install drivers for your i.LINK devices.
Not all i.LINK devices have been tested. Therefore, compatibility with all
i.LINK devices cannot be guaranteed.
Some devices might not support sleep or automatic off functions.
Do not connect or disconnect an i.LINK device while it is using an
application or when the computer is automatically shutting it down to
save power. Data might be destroyed.
Hardware, Utilities and Options
i.LINK (IEEE1394)
connector
3-27