Notes For Users In Australia And New Zealand - Toshiba TECRA S5 User Manual

The Ringer Equivalence Number (REN) assigned to each terminal device
provides an indication of the maximum number of terminals allowed to be
connected to a telephone interface. The termination on an interface may
consist of any combination of devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers of all the devices does not
exceed 5.
3. The standard connecting arrangement (telephone jack type) for this

Notes for Users in Australia and New Zealand

Modem warning notice for Australia
Modems connected to the Australian telecoms network must have a valid
Austel permit. This modem has been designed to specifically configure to
ensure compliance with Austel standards when the country/region selection
is set to Australia. The use of other country/region setting while the modem
is attached to the Australian PSTN would result in you modem being
operated in a non-compliant manner. To verify that the country/region is
correctly set, enter the command ATI which displays the currently active
setting.
To set the country/region permanently to Australia, enter the following
command sequence:
Failure to set the modem to the Australia country/region setting as shown
above will result in the modem being operated in a non-compliant manner.
Consequently, there would be no permit in force for this equipment and the
Telecoms Act 1991 prescribes a penalty of $12,000 for the connection of
non-permitted equipment.
Downloaded from LpManual.com Manuals
User's Manual
equipment is jack type(s): USOC RJ11C.
The IC registration number of the modem is shown below.
AT%TE=1
ATS133=1
AT&F
AT&W
AT%TE=0
ATZ
TECRA A9/ TECRA S5/ TECRA P5/ Satellite Pro S200
Canada: 4005B-ATHENS or 4005B-DELPHI
xii