Toshiba TECRA S5 User Manual page 80

Memory module
cover
8. Install the battery pack - refer to
9. Turn your computer over.
10. Turn the computer on and make sure the added memory is recognized -
Removing a memory module (Slot A and Slot B)
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
2. Remove the AC adaptor and all cables and peripherals connected to
3. Turn the computer upside down and remove the battery pack (refer to
4. Loosen the screw securing the memory module cover in place - please
5. Slide your fingernail or a thin object under the cover and lift it off.
6. Push the latches away from the module in order to release it - a spring
7. Grasp the module by its edges and remove it from the computer.
■
■
Downloaded from LpManual.com Manuals
User's Manual
Screw
Figure 3-8 Seating the memory module cover
Chapter 6, Power and Power-Up Modes, if required.
to confirmed it, Start -> Control Panel -> System and Maintenance ->
System icon.
Power indicator is off (refer to the
Chapter 1, Getting Started if required).
the computer.
Replacing the battery pack
Modes, if required).
note that this screw is attached to the cover in order to prevent it from
being lost.
will force one end of the module up at an angle.
If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
Hardware, Utilities and Options
Replacing the battery pack
Turning off the power
section in Chapter 6, Power and Power-Up
section in
section in
3-22