Table of Contents
Advertisement
Meter S40-T
Panel meter 72x36mm size for Pt100/RTD and Thermocouples
Panel meter for temperature signals, accepts Pt100/RTD with
2 and 3 wires, and thermocouples J, K, T, E, S, R, N, C, L and
X. Temperature display in degrees celsius (ºC) or fahrenheit
(ºF). Thermocouple cold junction compensation selectable.
Manual offset selectable. Selectable behavior for alarms in
case of sensor break ('to_high' or 'to_low').
Instrument with small 72x36mm standard DIN size. Resolu-
tion 4 digits and negative sign.
Management for up to 4 alarms with 1 or 2 setpoints each
alarm, with hysteresis and delays. Provides memory for maxi-
mum and minimum, display on selectable steps, password
and selectable levels of brightness.
Model
S40
-
T
Risk of electrical shock. Instrument terminals can be connected
to dangerous voltage.
Instrument protected with double isolation. No earth connection
required.
Instrument is in conformity with CE rules and regulations. See
"CE Declaration of Conformity" further in this document.
This instrument has been designed and verified according to the 61010-1
CE security regulation, and is designed for applications on industrial environ-
ments. See the "CE Declaration of Conformity" further in this document for
information on the category of measure and the degree of pollution levels
that apply.
Installation of this instrument must be performed by qualified personnel
only. This manual contains the appropriate information for the installation.
Using the instrument in ways not specified by the manufacturer may lead
to a reduction on the specified protection level. Disconnect the instrument
from power before starting any maintenance and / or installation action.
User's Manual S40-T
Order Reference
Power
-
-
H
-H
(85-265 Vac/dc)
-L
(11-60 Vdc
and 24/48 Vac)
Precautions on installation
FEMA ELECTRÓNICA - Page 2
Power options with universal AC and DC ranges, and space
for two additional control and/or signal retransmission mod-
ules.
Standard IP54 front protection, with optional upgrade to IP65
protection.
Connections via plug-in screw terminals and configuration
via three front push-buttons. For application on industrial
environments.
Option1
---
-
-R1
-R1
(1 relay)
-AO
-AO
(Analogue Output)
-
-
(empty)
(empty)
The instrument does not have a general switch and will start operation as
soon as power is connected. The instrument does not have protection fuse,
the fuse must be added during installation.
The instrument is designed to be panel mounted. An appropriate ventilation
of the instrument must be assured. Do not expose the instrument to excess
of humidity. Maintain clean by using a humid rag and do NOT use abrasive
products such as alcohols, solvents, etc.
General recommendations for electrical installations apply, and for proper
functionality we recommend : if possible, install the instrument far from
electrical noise or magnetic field generators such as power relays, electri-
cal motors, speed variators, ... If possible, do not install along the same
conduits power cables (power, motor controllers, electrovalves, ...) together
with signal and/or control cables.
Before proceeding to the power connection, verify that the voltage level
available matches the power levels indicated in the label on the instrument.
In case of fire, disconnect the instrument from the power line, fire alarm
according to local rules, disconnect the air conditioning, attack fire with
carbonic snow, never with water.
Option2
Others
-
---
---
-65
(1 relay)
(IP65)
-
(Analogue Output)
(empty)
Advertisement
Table of Contents
