Starting The Engine/Stopping The Engine - PowerLand PD2000 Owner's Manual

STARTING THE ENGINE/STOPPING THE ENGINE

Starting the Engine
1. Make sure that the AC circuit breaker is in the OFF position. The generator may be hard to
start if a load is connected.
2. Turn the fuel valve lever to the ON position.
3. Pull the choke rod to the CLOSE position.
4. Turn the engine switch to the ON position.
5. Pull the starter grip lightly until resistance is felt, then pull briskly.
NOTICE: Do not allow the starter grip to snap back against the engine. Return it gently to
prevent damage to the starter or housing.
With electric starter:
· Turn the engine switch to the START position and hold it there for 5 seconds or until the
engine starts.
·
When the engine starts, allow the engine switch to return to the ON position.
NOTICE: Operating the starter motor for more than 5 seconds can damage the motor. If the
engine fails to start, release the switch and wait 10 seconds before operating the
starter again.
If the speed of the starter motor drops after a period of time, it is an indication that the
battery should be recharged.
6. Push the choke rod to the OPEN position as the engine warms up.
Stopping the Engine
In an emergency:
To stop the engine in an emergency, move the engine switch to the OFF position.
In normal use:
1. Turn the AC circuit breaker to the OFF position. Disconnect DC battery charging cables.
2. Turn the fuel valve lever to the OFF position.
3. Move the engine switch to the OFF position.
15